Skip to Navigation
    Weber State University
   
 
  Sep 26, 2017
 
 
    
2017-2018 Catalog

Plastics and Composites Emphasis, Manufacturing Engineering Technology (BS)


Return to Programs Sorted by Degree Return to: Programs Sorted by Degree

Manufacturing Engineering Technology


  • Program Prerequisite: Not required.
  • Minor: Not required.
  • Grade Requirements: A grade of “C” or better in all major courses, support courses, and technical electives is required (a grade of “C-” is not acceptable) in addition to an overall GPA for all courses of 2.00 or higher. Also refer to the general grade requirements for graduation in the Degree Requirements  section of this catalog.
  • Credit Hour Requirements: Credit hours vary as shown for different emphasis areas: the BS in Manufacturing Engineering Technology with a Production Operations and Control Emphasis requires 125 credit hours, the BS in Manufacturing Engineering Technology with a Welding Emphasis requires 126 credit hours, and the BS in Manufacturing Engineering Technology with a Plastics and Composites Emphasis requires 121 credit hours. A total of 40 upper division credit hours is also required (courses numbered 3000 and above). Transfer students are required to take a minimum of 30 credit hours at Weber State University.

Advisement

All Manufacturing Engineering Technology students are required to meet with their faculty advisor at least annually for course and program advisement. Please call the department secretary at 801-626-6305 for the name of your advisor and to schedule an appointment.

Use Grad MAPs to plan your degree

Admission Requirements

Declare your program of study (see Enrollment Services and Information ). Refer to the Program Prerequisite on the previous page. There are no additional special admission or application requirements for this program.

General Education

Refer to Degree Requirements  for Bachelor of Science requirements. Consult with your advisor for specific general education guidelines.

Major Course Requirements for BS Degree


Plastics and Composites Emphasis


To be taken in addition to the courses required for the AAS Degree in Manufacturing Engineering Technology with a Plastics and Composites Emphasis.

Technical Electives (2 credit hours minimum)


A minimum of 2 credit hours of technical electives chosen from the following list are required. 

Return to Programs Sorted by Degree Return to: Programs Sorted by Degree