Skip to Navigation
    Weber State University
  Jan 21, 2018
2012-2013 Catalog ARCHIVED CATALOG: Content may no longer be accurate.

Welding Emphasis, Manufacturing Engineering Technology (BS)

Manufacturing Engineering Technology

  • Program Prerequisite: Not required.
  • Minor: Not required.
  • Grade Requirements: A grade of “C” or better in all major courses, support courses, and technical electives is required (a grade of “C-” is not acceptable) in addition to an overall GPA for all courses of 2.00 or higher. Also refer to the general grade requirements for graduation in the Degree and General Education Requirements  section of this catalog.
  • Credit Hour Requirements: Credit hours vary as shown for different emphasis areas: the BS in Manufacturing Engineering Technology with a Production Operations and Control Emphasis requires 124 credit hours, the BS in Manufacturing Engineering Technology with a Welding Emphasis requires 126 credit hours, and the BS in Manufacturing Engineering Technology with a Plastics and Composites Emphasis requires 126 credit hours. A total of 40 upper division credit hours is also required (courses numbered 3000 and above). Transfer students are required to take a minimum of 30 credit hours at Weber State University.


All Manufacturing Engineering Technology students are required to meet with their faculty advisor at least annually for course and program advisement. Please call the department secretary at 801-626-6305 for the name of your advisor and to schedule an appointment.

Admission Requirements

Declare your program of study (see Enrollment Services and Information ). Refer to the Program Prerequisite on the previous page. There are no additional special admission or application requirements for this program.

General Education

Refer to Degree and General Education Requirements  for Bachelor of Science requirements. Consult with your advisor for specific general education guidelines.

Major Course Requirements for BS Degree

Welding Emphasis

To be taken in addition to the courses required for the AAS Degree in Manufacturing Engineering Technology with a Welding Emphasis.