Dec 03, 2024  
2021-2022 Catalog 
    
2021-2022 Catalog ARCHIVED CATALOG: Content may no longer be accurate.

Manufacturing Engineering Technology (BS), Plastics and Composites Emphasis


Manufacturing Engineering Technology


  • Program Prerequisite: Not required.
  • Minor: Not required.
  • Grade Requirements: A grade of “C” or better in all major courses, support courses, and technical electives is required (a grade of “C-” is not acceptable) in addition to an overall GPA for all courses of 2.00 or higher. Also refer to the general grade requirements for graduation in the Degree Requirements  section of this catalog.  Seniors may petition to have one C- allowed in major and support courses.  Approval from the Program Coordinator and Department Chair is required.
  • Credit Hour Requirements: Credit hours vary as shown for different emphasis areas: the BS in Manufacturing Engineering Technology with a Production Operations and Control Emphasis requires 126.5 credit hours, the BS in Manufacturing Engineering Technology with a Welding Emphasis requires 123.5 credit hours, and the BS in Manufacturing Engineering Technology with a Plastics and Composites Emphasis requires 125.5 credit hours. A total of 40 upper division credit hours is also required (courses numbered 3000 and above). Transfer students are required to take a minimum of 30 credit hours at Weber State University.
  • Program Code: Manufacturing (8037BS), with Emphasis in Plastics & Composites (8058), Production Ops & Control (8059), or Welding (8060). 
  • CIPC: Manufacturing (150613), with Emphasis in Plastics & Composites (150607), Production Ops & Control (150613), or Welding (150614). ​

Advisement

All Manufacturing Engineering Technology students are required to meet with their faculty advisor at least annually for course and program advisement. Please call the department secretary at 801-626-6305 for the name of your advisor and to schedule an appointment.

Use Grad MAPs to plan your degree

Admission Requirements

Declare your program of study (see Enrollment Services and Information ). Refer to the Program Prerequisite listed above. There are no additional special admission or application requirements for this program.

General Education

Refer to Degree Requirements  for Bachelor of Science requirements. Consult with your advisor for specific general education guidelines.

Major Course Requirements for BS Degree


Plastics and Composites Emphasis


To be taken in addition to the courses required for the AAS Degree in Manufacturing Engineering Technology with a Plastics and Composites Emphasis.

Technical Electives (2 credit hours minimum)


A minimum of 2 credit hours of technical electives chosen from the following list are required.