Grade Requirements: A grade of “C” or better in all major courses, support courses, and technical electives is required (a grade of “C-” is not acceptable) in addition to an overall GPA for all courses of 2.00 or higher. Also refer to the general grade requirements for graduation in the Degree and General Education Requirements.
Credit Hour Requirements: Credit hours vary as shown for different emphasis areas: the AAS in Manufacturing Engineering Technology with a Production Operations and Control Emphasis requires 64 credit hours, the AAS in Manufacturing Engineering Technology with a Welding Emphasis requires 63 credit hours, and the AAS in Manufacturing Engineering Technology with a Plastics and Composites Emphasis requires 64 credit hours. Transfer students are required to take a minimum of 20 credit hours at Weber State University.
Assessment Requirements: Students will be required to complete certain assessment instruments as part of the overall requirements for receiving their associate’s degree. Please see your advisor or your department for specific information regarding assessment.
Program Code: 8037AAS with Emphasis codes Plastics & Composites (8058), Production Ops & Control (8059) or Welding (8060).
CIPC: 150613 with Emphasis codes Plastics & Composites (150607), Production Ops & Control (150613) or Welding (150614).
All Manufacturing Engineering Technology students are required to meet with their faculty advisor at least annually for course and program advisement. Please call the department secretary at 801-626-6305 for the name of your advisor and to schedule an appointment.
Refer to Degree and General Education Requirements for Associate of Applied Science requirements. Computer and Information Literacy as defined in this catalog is also required for the AAS degree. Consult with your advisor for specific general education guidelines.
Course Requirements for the AAS Degree
Core Courses (50 credit hours)
AAS Degree requirements for an AAS Degree in Manufacturing Engineering Technology, Production Operations and Control Emphasis, an AAS Degree in Manufacturing Engineering Technology with a Welding Emphasis, or an AAS Degree in Manufacturing Engineering Technology with a Plastics and Composites Emphasis will be met by completing the first two years of the respective BS Degree. All AAS Degrees will have the following courses in common.